== Back Powering the Pi via the J8 GPIO Header == == J8 GPIO ピンヘッダを経由した電源の供給について == It is possible to power the Pi by supplying 5V through the GPIO header pins 2,4 and GND.[[BR]] Raspberry PiのGPIOピンヘッダの5Vピン(2,4番ピン)とGNDピン(6, 9, 14番ピン等)経由で5Vを供給することができます。 The acceptable input voltage range is 5V ±5%.[[BR]] 受け付けられる電圧レンジは5V ±5%です。 On the B+ Pi, the 5V GPIO header pins connect to the 5V net after the micro-USB input, polyfuse and input 'ideal' safety diode made up of the PFET and matched PNP transistors.[[BR]] B+ Piでは、5V GPIOピンヘッダの5VはMicroUSBからの入力、ポリヒューズ、P型FETとマッチするPNPトランジスタで作られた「'理想'安全ダイオード」の後ろに接続されています。 The 'safety' diode stops any appreciable current flowing back out of the 5V micro USB should the 5V net on the board be at a higher voltage than the 5V micro USB input.[[BR]] ボード上の5VがmicroUSBの5Vよりも高い電圧だったときに、「安全」ダイオードがmicroUSBに電流が流れないように止める役割を果たします。 If the add-on board uses any more GPIO connector pins than the first 26 (i.e. is designed for a B+) and provides back-powering via the 5V GPIO header pins it is required to: もしアドオンボードが例えばB+用などで26pin以上のGPIOピンを使っていて、5V GPIOピンからPiに電源を供給するときに必要な条件は以下の通り 1. Implement a duplicate power safety diode before the HAT 5V net (which then feeds power back through the 5V GPIO pins) as shown in this diagram.[[BR]] 図で示すように、HATの5Vラインの手前に(5V GPIOピンに電流が流れるように)安全ダイオードを入れてください。 Alternatively provide some other mechanism to guarantee that it is safe if both the Pi PSU and add-on board PSU are connected. [[BR]] または、他の方法でもよいのでPiとアドオンボード両方に電源が接続された時の安全を確保してください。 It is still recommended to add this circuitry for new board designs that only implement the first 26 pins of the GPIO header but that also implement back powering.[[BR]] 新規の基板デザインだったとしても、Raspberry Pi Model A/Bの26pinのGPIOだけを使った電源供給を実装することをまだお勧めします。 2. Make sure that the supply that does the back-powering can supply 5V at a minimum of 1.3A to the Pi at all times (but recommended to support 2A). [[BR]] 常に5Vで最低1.3A(推奨2A)を供給できるようにする。 Under no circumstances should a power source be connected to the J8 3.3V pins. [[BR]] いかなる時でも3.3Vと接続しないこと。